S_GetFrame

Retrieves a specified frame from the source clip for each destination frame. This is meant to be used by animating the value of Get Frame to speed up, slow down, or reverse the input clip in an arbitrary way as desired.

In the Sapphire Time effects submenu.


Inputs:

Source:  The clip to be processed.

Parameters:

Get Frame:   Default: 0,  Range: 0 or greater.
The frame number of the source clip to access. This parameter should be animated to control the desired changes in motion. (If the Get Frame parameter is not animated it will just give a single still frame of that number for the entire clip.)

Interp Frames:   Check-box,  Default: off.
Selects the method to use for non-integer frame number references. If disabled, the nearest integer frame number is used with no interpolation. If enabled, it performs a weighted interpolation between the two nearest integer frame numbers and usually gives smoother results for slow motions.


See Also:

TimeWarpRGB
MotionDetect
TimeSlice
FreezeFrame
JitterFrames
RandomEdits
ReverseEdits
ReverseClip
 Sapphire Plug-ins Introduction


© 2009, GenArts, Inc. All rights reserved.