WipeDoubleWedge In the S_Wipes Plugin. Performs a wipe transition between two input clips using two wedge shapes. The Wipe Amt parameter should be animated to control the transition speed. Increase the Border Width parameter to draw a border at the wipe transition edges. Inputs: From:  Starts the transition with this clip. To:  Ends the transition with this clip.

Parameters:

Wipe Amt:   AutoTransition,  Default: 0,  Range: -0.5 to 1.5,  Shared.
The transition ratio between the From and To inputs. A value of 0 gives only the From input and a value of 1 gives only the To input. By default this parameter will automatically animate from 0 to 1 to perform a complete wipe.

Angle:   Default: 0,  Range: any.
The rotation angle of the wedge shapes in counter-clockwise degrees.

Sharpness:   Default: 2,  Range: 0 or greater.
The sharpness of the point of the wedges.

Wipe Direction:   Popup menu,  Default: IN.
Selects the direction of the motion of the wedges.

IN:  the two wedges described by angle and sharpness move inwards to perform the transition.

OUT:  the wedges move outwards to perform the transition. Note that wedges moving out from the sides is equivalent to wedges moving in from the top and bottom (with the sharpness complemented).

Edge Softness:   Default: 0,  Range: 0 or greater,  Shared.
The width of the transition edges. Larger values will cause softer, less visible edges in the wipe pattern.

Border Width:   Default: 0,  Range: 0 or greater,  Shared.
If positive, a colored border is drawn at the wipe transition edges, using the border color, opacity, softness, and shift parameters below.

Border Color:   Default rgb: [0.75 0.75 0.75],  Shared.
The color of the border. This has no effect unless Border Width is positive.

Border Opacity:   Default: 1,  Range: 0 to 1,  Shared.
The opacity of the border. Decrease to make the border transparent and allow the image under it to show through. This has no effect unless Border Width is positive.

Border Softness:   Default: 0,  Range: 0 or greater,  Shared.
The softness of the border edges. This has no effect unless Border Width is positive.

Border Shift:   Default: 0,  Range: any,  Shared.
Shifts the border ahead of or behind the transition edge. This has no effect unless Border Width is positive.

See Also:

WipeLine WipeCircle WipeRectangle WipeStar WipeClock WipeWedge WipeFourWedges WipeDots WipeChecker WipeStripes WipeRings WipeBlobs WipeCells WipeTiles WipePixelate WipeDiffuse WipeBubble WipeClouds WipeMoire WipePlasma WipePointalize WipeWeave

Sapphire Plug-ins Introduction

© 2010, GenArts, Inc. All rights reserved.