WipeClock In the S_Wipes Plugin. Performs a clock wipe transition between two input clips. The Wipe Amt parameter should be animated to control the transition speed. Increase the Border Width parameter to draw a border at the wipe transition edges. Inputs: From:  Starts the transition with this clip. To:  Ends the transition with this clip.

Parameters:

Wipe Amt:   AutoTransition,  Default: 0,  Range: -0.5 to 1.5,  Shared.
The transition ratio between the From and To inputs. A value of 0 gives only the From input and a value of 1 gives only the To input. By default this parameter will automatically animate from 0 to 1 to perform a complete wipe.

Center:   X & Y,   Default: [0 0],  Range: any.
The location of the clock center in screen coordinates relative to the center of the frame. This parameter can be set by enabling and moving the Center Widget.

Angle Open:   Default: 0,  Range: any.
The angle in degrees at which the wipe opens at the start.

Angle Close:   Default: 0,  Range: any.
The angle in degrees at which the wipe closes at the finish. If Angle Open and Close are not equal, both edges will rotate. For example for a double edged clock wipe set Angle Close to 180.

Direction:   Popup menu,  Default: Clockwise.
Selects the direction of the edge rotation.

Clockwise:  wipes with an edge rotating clockwise.

CounterCW:  wipes with an edge rotating counter clockwise.

Edge Softness:   Default: 0,  Range: 0 or greater,  Shared.
The width of the transition edges. Larger values will cause softer, less visible edges in the wipe pattern.

Border Width:   Default: 0,  Range: 0 or greater,  Shared.
If positive, a colored border is drawn at the wipe transition edges, using the border color, opacity, softness, and shift parameters below.

Border Color:   Default rgb: [0.75 0.75 0.75],  Shared.
The color of the border. This has no effect unless Border Width is positive.

Border Opacity:   Default: 1,  Range: 0 to 1,  Shared.
The opacity of the border. Decrease to make the border transparent and allow the image under it to show through. This has no effect unless Border Width is positive.

Border Softness:   Default: 0,  Range: 0 or greater,  Shared.
The softness of the border edges. This has no effect unless Border Width is positive.

Border Shift:   Default: 0,  Range: any,  Shared.
Shifts the border ahead of or behind the transition edge. This has no effect unless Border Width is positive. For the clock wipe pattern, the shift amount is limited to within the area of Edge Softness.

See Also:

WipeLine WipeCircle WipeRectangle WipeStar WipeWedge WipeDoubleWedge WipeFourWedges WipeDots WipeChecker WipeStripes WipeRings WipeBlobs WipeCells WipeTiles WipePixelate WipeDiffuse WipeBubble WipeClouds WipeMoire WipePlasma WipePointalize WipeWeave

Sapphire Plug-ins Introduction

© 2010, GenArts, Inc. All rights reserved.