FlickerRmMatteColor In the S_FlickerRmMatte Plugin. Removes temporal color changes from the Source clip using a Matte clip to specify the area where the average color should remain constant. To use this effect, select a Source frame that has the desired color within the Matte, and hit the Set Hold Color button. When other frames are processed, their color will be scaled so the average color within the Matte is equal to the Hold Color. Inputs: Source:  The clip to remove color changes from. Matte:  The white of this clip specifies which Source areas to measure the flicker from. It can be inverted with the Invert Matte parameter.

Parameters:

Set Hold Color:   Push-button.
Pressing this button sets the Hold Color parameter to the average Source color within the Matte at the current frame. It causes the output to equal the Source at this frame. (This will not work properly when in 'Redraw:Never' mode.)

Hold Color:   Default rgb: [0.5 0.5 0.5].
The requested average output color for the area within the Matte.

Invert Matte:   Check-box,  Default: off,  Shared.
If enabled, the black and white of the matte are inverted before use.

Measured Flicker R:   Default: 0,  Range: 0 or greater.
When processing, this parameter is automatically adjusted to record the amount of flicker in the red color channel at each frame. You can copy the keyframes to a parameter in other effect in order to match the flicker in a different clip, or adjust the brightness on certain frames. Changing this parameter manually has no effect.

Measured Flicker G:   Default: 0,  Range: 0 or greater.
When processing, this parameter is automatically adjusted to record the amount of flicker in the green color channel at each frame. You can copy the keyframes to a parameter in other effect in order to match the flicker in a different clip, or adjust the brightness on certain frames. Changing this parameter manually has no effect.

Measured Flicker B:   Default: 0,  Range: 0 or greater.
When processing, this parameter is automatically adjusted to record the amount of flicker in the blue color channel at each frame. You can copy the keyframes to a parameter in other effect in order to match the flicker in a different clip, or adjust the brightness on certain frames. Changing this parameter manually has no effect.

See Also:

FlickerRemoveMatte

FlickerRemove FlickerRemoveColor FlickerMatch FlickerMatchColor FlickerMatchMatte FlickerMchMatteColor Flicker

Sapphire Plug-ins Introduction

© 2010, GenArts, Inc. All rights reserved.