BlurDirectionalMask In the S_BlursMask Plugin. Blurs the source clip in a single direction using a gaussian, triangle, or box filter. It can also blur each channel by different amounts. Similar to BlurDirectional, but a Mask input specifies which areas of the source are to be blurred. Inputs: Source:  The clip to be processed. Mask:  The blur is only performed on regions of the source clip specified by the bright areas of this input. Pixels outside this mask are not blurred, and do not contribute to the resulting blurred pixels within it. Only the red channel of this input is used.

Parameters:

Angle:   Default: 45,  Range: any.
The direction of the blur. An angle of 0 produces a horizontal blur, and an angle of 90 produces a vertical blur. This parameter can be adjusted using the Angle Widget.

Blur Amount:   Default: 0.5,  Range: 0 or greater.
Scales the width of the blur. This parameter can be adjusted using the Blur Amount Widget.

Blur Red:   Default: 1,  Range: 0 or greater.
The blur width of the red channel, relative to Blur Amount.

Blur Green:   Default: 1,  Range: 0 or greater.
The blur width of the green channel, relative to Blur Amount.

Blur Blue:   Default: 1,  Range: 0 or greater.
The blur width of the blue channel, relative to Blur Amount.

Filter:   Popup menu,  Default: GAUSS.
The type of convolution filter to blur with.

BOX:  uses a rectangular shaped filter.

TRIANGLE:  smoother, uses a pyramid shaped filter.

GAUSS:  smoothest, uses a gaussian shaped filter.

Bias:   Default: 0.5,  Range: 0 to 1.
Varies the weight of the pixels along the path of the blur, which gives the appearance of trails or streaks in a single direction. A value of 0.5 weights all pixels evenly. A value of 1 causes the weight to increase toward the direction of the blur, while a value of 0 has the opposite effect.

Shift:   Default: 0,  Range: any.
Shifts the image in the direction of the blur. A negative shift amount shifts the image in the opposite direction.

Shift Red:   Default: 0,  Range: any.
Additional amount to shift the red color channel.

Shift Green:   Default: 0,  Range: any.
Additional amount to shift the green color channel.

Shift Blue:   Default: 0,  Range: any.
Additional amount to shift the blue color channel.

Edge Mode:   Popup menu,  Default: REFLECT.
Determines the behavior when accessing areas outside the source image.

BLACK:  Areas outside the source image are treated as black, which can produce dark areas around the edges of the image. Select this for fastest rendering.

REPEAT:  Repeats the last pixel outside the border of the image.

REFLECT:  Reflects the image outside the border.

Scale Result:   Default: 1,  Range: 0 or greater.
Scales the brightness of the result.

Offset Darks:   Default: 0,  Range: any.
Adds this gray value to the darker regions of the result. This can be negative to increase contrast.

Mix With Source:   Default: 0,  Range: 0 to 1.
Interpolates between the blurred result (0) and the original source (1). 0.1 can give a nice misty effect since it mixes only a little of the source in.

Invert Mask:   Check-box,  Default: off.
If enabled, inverts the mask input so the effect is applied to areas where the Mask is black instead of white.

See Also:

BlurMask BlurMonochromeMask BlurChannelsMask BlurChromaMask

BlurDirectional

RackDefocus DefocusPrism EdgeBlur BandPass BlurMotion

Sapphire Plug-ins Introduction

© 2010, GenArts, Inc. All rights reserved.