S_SwishPan Transitions between two input clips by sliding one clip off the frame and the other clip on, and adding motion blur to give the appearance of a quick pan. This works best when the duration of the transition is short. In the Sapphire Transitions effects submenu. Inputs: From:  Starts the transition with this clip. To:  Ends the transition with this clip.

Parameters:

Wipe Amount:   Default: 0,  Range: -0.5 to 1.5.
Determines the transition ratio between the From and To inputs, and would normally be animated from 0 to 1 to perform a complete transition. The curve controlling this parameter can be adjusted for more detailed control over the timing of the wipe.

Direction:   Popup menu,  Default: Left.
Direction that the clips move during the transition.

Left:  Moves right-to-left

Right:  Moves left-to-right

Up:  Moves upward.

Down:  Moves downward.

Blur Amount:   Default: 0.4,  Range: 0 or greater.
Amount of motion blur to use. If the direction is left or right, the blur is horizontal. If the direction is up or down, the blur is vertical.

Overlap:   Default: 0,  Range: any.
Amount to overlap the two clips. Where the clips overlap, they will be screened together. This is useful for eliminating bad edges.

Slow In:   Default: 0.5,  Range: 0 to 1.
If positive, causes the transition to start more gradually.

Slow Out:   Default: 0.5,  Range: 0 to 1.
If positive, causes the transition to end more gradually.

See Also:

WipeLine WipeCircle WipeRectangle WipeStar WipeClock WipeWedge WipeDoubleWedge WipeFourWedges WipeDots WipeChecker WipeStripes WipeRings WipeBlobs WipeCells WipeTiles WipePixelate WipeDiffuse WipeBubble WipeClouds

Sapphire Plug-ins Introduction

© 2009, GenArts, Inc. All rights reserved.